The microscope lighting bulbs are ordered differently due to different working hours. If the bulb is damaged and replaced, the system must be reset to avoid unnecessary losses to the machine. Turn off the lighting system or adjust the brightness to the minimum every time the machine is turned on and off to avoid sudden high-voltage shocks from damaging the light source.
In order to meet the requirements for the selection of the surgical site, the size of the field of view, and the clarity during the operation, the doctor can adjust the displacement aperture, focal length, height, etc. through the foot control board. When adjusting, move lightly and advance slowly. When reaching the limit position, stop immediately. Overtime idling will damage the motor and cause adjustment failure.
After the microscope is used for a period of time, the joint lock will be too dead or too loose. At this time, it is only necessary to restore the joint lock to normal working condition according to the situation. Every time you use the microscope, you should routinely check the joints for looseness, so as not to cause unnecessary trouble during the operation.
After each use, use absorbent cotton cleaner to wipe off the dirt on the microscope, otherwise it will be difficult to wipe clean if it takes too long. Cover it with a microscope hood and keep it in a ventilated, dry, dust-free, and non-corrosive gas environment.
Establish a maintenance system, regular maintenance inspections and adjustments by professionals, and carry out the necessary overhaul and maintenance of the mechanical system, observation system, lighting system, display system, and circuit parts. In short, be cautious when using the microscope, and don't handle it roughly. In order to prolong the service life of the operating microscope, it is necessary to rely on the serious working attitude of the staff and the care and care of the microscope to keep it in a good operating condition and perform better.
